Re: Best way to clean electrical switches and connections?
Make sure ALL cables are disconected from the batts.. If it has a toggle switch make sure you flip it into the tow mode before unhooking the batts.. then you will be able to clean all of the components 1 by 1.. i would use a wire brush and once they are clean you can put a little bit a dielectric grease on them.. as far as the fnr switch goes, you might have a loose conection on it or it might be dirty as well.. I think it might be a 9/16 to tighten it.. hope this helps you.. remember to make sure ALL power is killed before you start removing connections to clean them.. ESP. the toggle switch if it has one..
|