Re: 89 EC25 3pg rebuild questions
The wrist pin shows some bluing due to heat and was tight in the piston, there were no spacers for needle bearings and they slid freely on pin and rod exposing needles if slid back and forth. rod bearing feels good up & down, has typical side to side movement. I am also hanging up on the crankshaft, whole assembly rotates smooth but there is a little up/down side to side movement, tic/tock sound. Probably have to wait till after Christmas and see how much money I "don't" have left. If I decide to by the whole long block kit I see prices range and would assume all are made in India, what retailer would be suggested or not from experience.
Thanks again,
Scott
|