Re: 2007 Emerge Reducer Replacement
If the yellow wire was hooked up to the solenoid it would be the 48V positive. The black wires are grounds and the one clipped into the harness should be your 12v to lights. Id check to see if there is any voltage at the red wire on the harness just to be safe. If not, check continuity from the red wire clip to your headlight switch. Id guess it is. If thats the case, your input 48v wire can go to the same big post on the solenoid. The blacks are grounds and to be safe id put them.on the main ground battery unless your certain shich side of the solenoid is ground. And your 12v output would go.to the red wire on the harness...this is assuming that the red wire is indeed the same wire that runs to.your headlight switch.
|