[essness]

Don’t know if this is worthy of a sticky?
Electric lift for workhorse dump bed components that will seamlessly fit factory mounts.

Warner Electric liner actuator# K2xG20 (2200 lb cap, 6” throw) You can use any that is 14” to 15” closed dimension.

Napa switch# TG7071 (Momentary on /off/ momentary on 6 pole)

Napa 30amp breaker# 782-3105

1) ½” x 3” clevis pin
1) ½” x 1-7/8 to 2” clevis pin
2) 3/8” spacers (I used 1/2" SAE washers)
3) cotter pins (appropriately sized for clevis pins)

Red and black primary wire, I used 14 gauge about 15’ ea.
15’ 1/2” split loom cut to length.

cost me ttl $143.00