View Single Post
Old 12-30-2013, 09:27 PM   #5
Marshred
Not Yet Wild
 
Marshred's Avatar
Club Car
 
Join Date: Apr 2013
Location: Southwest Louisiana
Posts: 31
Default Re: Inside An MCOR 01-04 DS

To open this up without breaking it....
I used a Rockwell Sonic cutting tool. I installed the thinnest curved blade. I put the MCOR in a wood vice so that when the blade was resting on the vice, it would cut just below the glued seam. Be careful cutting around the curved portion as you don't want to cut into the POT shaft. There is a glued pin on each side of the shaft, so be sure to cut deep enough to cut them but not the shaft!!! Carefully pop apart!
The contact pins must be desoldered from the PCB in order to lift it out. You can also desolder the switch posts at this time also. Lift the PCB out and unscrew the switch from the PCB.
It has some sort of dielectric grease on the wiper and PCB surface, so it will need to be cleaned off and recoated after changing the switch.
The switch I ordered should be here the middle of next week. I will post pics of the repaired MCOR.
Switch with shipping: $35
Marshred is offline   Reply With Quote