View Single Post
Old 06-10-2008, 01:25 PM   #4
30-A rider
Getting Wild
 
Join Date: Feb 2008
Location: Santa Rosa Beach Florida
Posts: 76
Default Re: Converter installation

Quote:
Originally Posted by mturkett View Post
Install converter. 1 fused wire to positive of battery #6 and 1 to negative of battery #1. Two other wires go to the pos/neg of lights. If it has a fifth wire it goes to the dead side of the key switch. Make sure it is on the dead side (non hot side with the key off). Converters always pull a small amount of current even if the accessories are off.

Problem with adding an extra 12 volt battery is where to put it. Also, you have to charge it separately from the rest of the cart's pack.

Ok but what about brake light switch, what about blinkers, what if I wanted to install a radio? Does all of this get installed off of the key switch when in on position? Im an electric idiot so I need it spelled out.

Thanks much for your reply!
30-A rider is offline   Reply With Quote