[aldrichd]

Bruce, I cant find an inline fuse unless it's buried in this wiring mess somewhere. I pulled the solenoid out, removed the wires from the big terminals, and tested the resistance on the big posts with the key off and direction switch in neutral and got no reading (OL). I then turned everything on, stepped on the accelerator, but no clicking from the solenoid. I then checked the resistance again, and got a 0 reading. I then tested the voltage across the small terminals and still got a 0 reading so I'm assuming the solenoid is good based on other things I have read. With all the wires hooked up I had roughly 48 volts on both big terminals. Would that mean my controller is the most likely culprit? Is there a way to check that, or is there something else I should check?