[ianb1]

Thanks for the reply - I followed those instructions but I am not understanding the following:

"Separate the 6 pin connector (only 4 are used) between the pedal box and the controller that's located on the passenger's side of the battery compartment.
If the voltage goes to 14 volts, the sensor is faulty.
If the voltage remains below 14 volts, the controller is faulty. "

I assume that this is the 6 pin connector that sits on top on my controller?
Am I measuring the voltage at the connector or on top of the controller at the pins?
In either case there is not voltage present at the white wire which is what lead me to the ITS but re-reading this it sounds like my controller is dead?

Cheers,

Ian.