Re: Yamaha G16E Troubleshooting Question
Update...
After sitting for a day or so, while hooked up directly to the battery the controller came back on. I have now rewired the controller through the solenoid and have it powered on and ready.
When I press the accelerator I get nothing. I jumped the 2 large posts on the solenoid and can get the wheels to spin.
On the All Trax controller I get 1 red LED blink when I press the accelerator, which according to their website indicated "1 Red = Throttle Position Sensor Over Range. Check for open wires.". So I assume I have a bad ground.
Was wondering if there would be a best place to start when looking for a ground issue? I cleaned the connection at the receptacle which didnt help.
I will be looking at it again tonight when I get off of work so any advice you guys have would be great.
Thanks
|