Quote:
Originally Posted by bflorin
Well, I'm not mixing them...previous owner did. ;) The second diagram you posted was what I first printed out and was expecting. But this controller didn't have the A2 blade on it or a run/tow switch. He only had about 25 working volts, so hopefully he didn't smoke anything. New solenoid also.
So what is actually supposed to go on the two large posts on the solenoid? The controller wires and diode are on the smaller posts currently.
Does this 250 ohm / 5w resistor physically go in a break between the B+ and + battery hookup?
Thanks for the input!
Blake
|
I don't understand your question. In this diagram, the high current cables are highlighted red. I just sent you the original which HAS an A2, which yours doesn't have.
I'm sending you a diagram for an AXE controller, which I think is easier to read. The controller pin numbers for the wires (not cables) are different.
Maybe between the two you can figure it out. There are two different circuits in a series. The low current wires - sometimes referred to as the control circuit or the solenoid activation circuit, and the high current cables circuit.