[kuntrywelder]

The motor tag is all but unreadable, it set for a long time at an old golf course shoved back into the bushes. I didn't wire up the old F/R switch because the rig is so light you just pick up the front end and spin it around. The cables are all welding cable. The only thing I can read on the label very well is 36V with no other listing. Maybe I just expect too much from this old motor. I did locate some aftermarket brushes but haven't put them in because I read somewhere you should run the OEM brushes as long as possible because the aftermarket ones were not as good. Maybe I should just look around for another motor. Thanks.