[Jhammer]

Correction pin 17 is going to the main solenoid which is correct. So after sending hours tonight I'm back to the hall effect sensor and micro switch being the problem. So when testing the voltage of the sensor I show zero volts but when I push the pedal down it jumps all the way to pack voltage immediately, I mean not even 1/8th of a inch and the voltage is maxed out. I unhooked the sensor all together and it did the same thing like the hall effect sensor was doing nothing. Once the micro switch was released from it postion pressing on the throttle rod it goes to full voltage no gradual increase. I know this is wrong but did I just buy a brand new bad hall effect sensor? I also adjusted the rod to be further from the hole of the sensor thinking I need more space to no avail.