[KSlocum]

went through the cart again today. Found that the master solenoid was not pulling in and I found two more bad solenoids. The master solenoid is good but apparently the micro switch in the speed control is bad. Will be taking that apart tomorrow. As I suspected the limit switch on the F-N-R switch is wrong. There is no way the solenoids could pull in because when in F or R that switch is open and interupts the neg half of the solenoid control circuit. It doesn't look as if it has been replaced but it sure wouldn't work. Will replace it with with a NO, (normally open) switch. The master Solenoid would pull in when I hot wired it but not with the speed control. I jumpered the #2 solenoid's positive lead over to the master and away I went. It actually made the trip around the house. Tickled the heck out of me. Thanks for the help.