Powerwise Charger works but doesn't fully charge batteries
I have 36v powerwise charger II. I have replaced the batteries in the last 6 months which are Trojan T105's. I have an digital volt meter that is attached to the pack and displays the volts all the time. After the charger turns off the volt reading will drop to 37.8 or 37.6 almost immediately. I never see the volts go up over 40 as was suggest should happen. The ammeter is not working on the charger. What I am trying to figure out is what is the most likely cause for the charger not charging the pack fully? Would the ammeter not working cause this issue? Do you think the control board is going bad or is the another likely culprit? I have cleaned all the battery terminals even though they are new. I have ordered new cables but they are still on their way. Any suggestions would be great. Thanks!!
|