Well since I have two carts now apart, I felt I needed to look up some information, since I had it I felt it was necessary to share this will everyone else. I would think that someone else could use this information as well. If I have missed something on the list let me know and I will add it to the list accordingly, but I think I have gotten most of it. Hope this helps someone.
This is a list of Rivets needed if doing a complete frame break down. I pulled this information from Service Parts Manual starting 2003. Some/Most of these parts will also work on older EZGO models back to 1994, to the Medalist. There are some parts that are different, please refer to your cart to make sure. The Front Cowl Rivels are expandable (Molley Type)
1. Body Front
Dash area 3/16” x 1” Aluminum x 9
Vinyl Trim sides that hold mat down and bottom of dash 3/16” x 1” AL x 10
Bottom of Front Cowl 3/16” x ¾” Stainless x 2
Front Shock Cover ¼” x 1” x 2
Key Switch Plate, it was not listed, but a set of screws will work.
2. Body Mid-Section Floor Pan and Fire Wall Area
Rivet 3/16” x 9/16” x 16
Rear fender area ¼” x ¾” LG x 8
3. Body Rear
Seat Hinge 3/16” x ¾” Stainless x 4
Bag Well ¼” x ¾” x 2
Rear Bumper 3/16” x 9/16” Aluminum x 4
Bottom of Rear Body Rocker Panel area ¼” x 9/16” Aluminum x 4
Rocker Panels 3/16” x 15/16” x 4
Front of Rear Body Floor Pan Area 5/32” x 9/16” x 6
Horn Button if equipped Rivet 3/16” x 1” LG x 2
Charger Receptacle 3/16” x 1” Aluminum x 4