2003 G22E Motor Cap Re-Attachment
I have a 2003 G22E. I am an idiot and removed the two screws near the speed sensor that I now know secure the bearing retainer. In order to fix that issue I need to remove the motor end cap. I removed the four long bolts that secure the end cap but had to pull quite a bit to separate the cap from the motor. I pulled so much that the motor cylinder came out too.
My issue now is lining everything up to get the four bolts secured again. The bolt passed through a small eye hole in the motor and then into a threaded cavity at the far side. Any tips on how do get this all lined up correctly? A video would also be awesome if anybody know of one.
I am a newbie but would really like to do this.
|