[manaus24]

Originally Posted by rstacy

For the bearing plate - Use a small pick to rotate the plate in to position. You can easily see when the holes are lined up. Now get a longer screw of the same thread size. Screw the longer screw in by a few threads and use it to pull the plate up. Hold the plate in position and install one of the factory screws in the other hole. Remove the longer screw and install the remaining factory screw.

For the armature - Push the motor brushes far enough in to the brush holders to actually disengage the springs.
Insert the armature in to the end cap and push the brushes back in to position. Make sure that brush springs are now engaged.
Slide the stator assembly over the armature and line up and reinstall the 4 bolts.

Thank you..very helpful