[bradgibson]

Yes I am sure its not exhaust dripping on the case. When I could get the motor to fire, there were small bubbles coming out of where the split in the case is, and I could tell right away what was going on.
Yup, the engine bolts have Phillips heads on them, at least mine did. I did strip one, but managed to tap it with a punch and it finally came also. Thanks for the clutch pully advice.
But back to my original question about reinstalling the top end. Everything looks/feels/appears to be in good condition. There is some slight carbon build up on the top of the piston that will come off with a wire brush, rings are good and tight still. Can I put it all back together?
Thanks again guys