Re: CC DS 4-12v to 6-8v conversion
Thanks cgtech for the post and canine for the OBC information. Very good stuff. I recently did the conversion on a 2006 DS. Question for cgtech. Why did you remove the 4 spacers? I removed the two angle supports according to your plan with a hammer and chisel. When it got to removing the four spacers, it looked as though this would not be necessary. It appeared that the current 12 volt holders and rods along with bottom support would adequately support the 8 volt batteries. Therefore I only added two 1 1/2 inch strips of 1/8 inch alum to support each battery.
|