Re: 36 volt ez go/ curtis controller wont move
I dont have the four pin molex connector. Just the spade connectors J1 J2 and J3. What should the throttle voltages be and where do you take them? I did a reading on the pins J1 2 and 3 disconnected from the throttle inductive pickup assembly. I swapped a new throttle assembly in and continuity checked the wires and micro switch all good. I used the negative meter lead on B- and had key voltage on J3 and I think .4 to .7 volts on pin 2 when the pedal was pressed from off to full throttle.
|