View Single Post
Old 07-22-2022, 02:59 PM   #34
five5cooks
Not Yet Wild
E-Z-GO
 
Join Date: Sep 2020
Location: Lexington NC
Posts: 42
Default Re: 86 Marthon Build Log

A week off from the cart build gave me a little time to recharge in the mountains. This morning it was back to the build though. Mounted my new motor along with swapping out hardware on the Alltrax mount. I also began making up my cables, this 2ga welding wire is no joke to cut. Finally ended up using a hacksaw to make short work of the cuts. The trick I found was that I could press the cable in the crimpers before removing the silicone sleeve. This helped it maintain the shape tight enough that it would slide easily into the lugs and they could be crimped. I am putting an orange sleeve over the cables, although they clearly do not need it. Now to go find my heat gun to get the heat shrink finalized. The only question I have had is the differences I have seen in other members wiring vs the schematic provided by Alltrax for hooking up the SW202.
Attached Images
File Type: jpg IMG_2647.jpg (256.8 KB, 0 views)
File Type: jpg IMG_2648.jpg (262.8 KB, 0 views)
File Type: jpg IMG_2649.jpg (258.9 KB, 0 views)
File Type: jpg IMG_2653.jpg (207.7 KB, 0 views)
File Type: jpg IMG_2654.jpg (241.5 KB, 0 views)
five5cooks is offline   Reply With Quote