Re: Demonstrated Lightning
I made a mistake in describing the wiring connections in the first post of the thread.
Of the two small black wires on the solenoid that I shorted to pack + , one goes to the controller B-, (not to pin position 4 as I previously stated) & the other goes to the backup beeper which was disconnected years ago.
The short probably also went through the solenoid coil & out the two small red wires. One to controller pin #4, the other to MS3 switch N/O.
The controller is probably burnt toast but I'd like to prove it before spending the bucks to replace it. Any suggestions for doing this would be highly appreciated. I also don't want to damage the solenoid circuit since its ok now.
I'll also check out the motor before going any farther.
|