Quote:
Originally Posted by JohnnieB
Suggest you remember which drive system your cart has before ordering replacement controllers that won't work with the motor in cart.
Hint: A Curtis 1205 controller is for a series drive.
|
Ah, I had just looked at the pin names on the motor and didn't realize that both Series and SepEX used the same 4 pin names (A1/A2 & S1/S2). Good to know.
Quote:
Originally Posted by kgsc
If it is a 99 with a run/tow switch it is probably a DCS but would validate that before ordering anything.
|
It is a DCS cart.
Quote:
Originally Posted by kgsc
Did you check the solenoid? Chances are it took out the controller but I have seen this just take out the solenoid.
|
Good point, there was not voltage on the blue wire that feeds the solenoid, but will have to take a look and verify that its good as per
https://shop.fsip.biz/Image/GetDocument/en/157 an open solenoid coil can cause 0 volts there.
Aaron Z