View Single Post
Old 12-04-2021, 12:34 PM   #41
Not Yet Wild
Join Date: Dec 2021
Posts: 9
Question Re: axle bearing and seal replacement.

Originally Posted by scottyb View Post
It sounds like maybe the bearing is not fully installed (not seated in the correct location)
I use a 6" piece of 3/4 steel pipe to seat the bearing. place the axle in a vice with the bearing end up. Slide the bearing on followed by the pipe. Tap the pipe with a hammer until the bearing is seated in the proper location.
Thank you for your response, I used a socket to punch it in but nothing, I bought 2 different sets of bearings ,it seems like it larger then the inner Groove of the hub.F324EBE5-BFAD-4179-8408-580817662EC4.jpg


Here is a update: passenger side rear axle bearing was prefect to install : But driver rear axle bearing mystery grooves, bearings is too thick. See pictures F324EBE5-BFAD-4179-8408-580817662EC4.jpg

Attached Images
File Type: jpg 065DEE1D-977F-47EA-9142-A97FA993A591.jpg (19.5 KB, 0 views)
File Type: jpg BD7EA0B6-3FC4-477D-B3A3-1D955F5FE64B.jpg (19.2 KB, 0 views)
Life is offline   Reply With Quote