Quote:
Originally Posted by dbmachine
To fatten would be to turn the screw clockwise or counter clockwise and how many turns???
|
The idle mixture screw is a true fuel mixture and not an air bleed so you should back it out counterclockwise to richen the idle fuel/air. There may be a plastic limiter cap on it which prevents more than a small adjustment. This can be removed if you are very careful. As to how much to back it out, I would experiment with 1/4 turns at a time and see if it helps. If you have to go out more than 1 turn, you may need to disassemble and clean out the carb. When I installed my Plowman's jet kit, I was surprised at how gunked up the carb was. A good cleaning might solve your initial problem too.