Quote:
Originally Posted by mattadata
1. Can anyone explain the difference between an EZGO PDS cart and an EZGO TXT48 cart?
<snip>
2. My question: Is a TXT48 better, worse, or the same as PDS?
3. Should I be any more concerned about putting and Alltrax XCT 500 (limited to 400A in software) on the stock motor?
<snip>
|
1. Same body, but different drive system:
a. Different voltage battery pack.
b. Different controller.
c. Different control wiring harness.
d. Different motor. (I'm not 100% sure on the motor, but strongly suspect it.)
2. The 36V PDS was probably a little better that the 48V OEM version. The published stock performance is about the same, so EZGO might have used a less robust motor to get about the same performance at a higher voltage. I'm just speculating, so check out the model number on the motor.
3. No, if the TXTE-48 is in fact a Curtis 1264, it is a 400A controller. (The Curtis 1206HB is a 250A controller).
You can adjust the RPM limit on the XCT, so your cart ought to be faster than it was when stock.