Cushman Titan
New to forum. I have an older Cushman Titan which I am told is the same as an EZGO. No vin plate or serial #.
36V system, has rocker switch and solenoids for the FNR.
Bought it non-running.
New batteries, tested at 38+V.
New Curtis 1204 controller.
Solenoid energizes correctly, and POT tests good.
37+ volts to controller input lugs.
Voltage coming from controller output lugs varies from -1V to +1.6V depending on POT position.
Motor: one of the motor posts (s2) show continuity to frame, and the s1 and s2 posts show no continuity to each other.
Any guidance would be appreciated.
I am thinking the motor is bad (stator shorted) and the new controller is bad as well.
Last edited by remonroe; 05-21-2013 at 01:21 PM..
Reason: more info
|