Buggies Gone Wild Golf Cart Forum - View Single Post

rabbitreborn · 06-25-2011, 04:05 PM

That controller setup reminds me more of a Melex (which would look VERY similar to an E-Z-GO since Melex was a Polish made cart based on the E-Z-GO Marathon design)

That being said, The pic of the controller you posted makes me concerned... it appears that there is a gap in the sealant of the controller that could have allowed water/dirt inside the unit.

If your meter is going to O/L when doing the test on the pot box, that typically means the pot is going out of range which would make me suspect a bad pot.

Try jacking up the rear end and place your volt meter on the 2 small posts of the solenoid and then depress the accelerator pedal. you should get full battery voltage at that point, if not, we need to look at the activation circuit of the cart.

06-25-2011, 04:05 PM	#2
rabbitreborn Gone Wild Join Date: Jun 2010 Location: Central Florida Posts: 2,757	Re: curtis pmd troubleshoot help That controller setup reminds me more of a Melex (which would look VERY similar to an E-Z-GO since Melex was a Polish made cart based on the E-Z-GO Marathon design) That being said, The pic of the controller you posted makes me concerned... it appears that there is a gap in the sealant of the controller that could have allowed water/dirt inside the unit. If your meter is going to O/L when doing the test on the pot box, that typically means the pot is going out of range which would make me suspect a bad pot. Try jacking up the rear end and place your volt meter on the 2 small posts of the solenoid and then depress the accelerator pedal. you should get full battery voltage at that point, if not, we need to look at the activation circuit of the cart.