Re: curtis pmd troubleshoot help
ok, here is the activation circuit on that cart (wire colors could be anything so I am just going to tell you how they route):
from D/S front inside battery to the keyswitch.
from Keyswitch to the micro on the F&R.
From F&R micro to a micro on the Pot Box
From PotBox Micro to the solenoid.
From the solenoid to the controller.
On the ground side, it usually jumps from the B- on the controller to the solenoid.
that being said......
Key on, Cart in gear, pedal depressed, you should see full battery pack voltage between the 2 small posts of the solenoid. If you are seeing that and the solenoid doesn't click, you have a bad solenoid. If you are not seeing that, you have to retrace the circuit until you find where you are losing power at.
If the solenoid DOES click, and the wheels still do not turn, you have to check voltage between the main pack negative and each of the large posts of the solenoid. If they match and the wheels still don't turn, then we can test further. If they Don't match, then you have a bad solenoid.
If they do Match, then we can run tests further......
|