Re: 83 EZGO Drive Clutch Replacement
Yup......new drive clutch and new driven clutch. The carb was replaced by the previous owner.
After getting the motor back in, I discovered most of the wires going to/from the starter/generator were damaged. A few of them had melted insulation in places (where they got up against the exhaust). The eyelet broke on one of them, so I ordered all new cables. They came in yesterday and I installed them today.
Put it up on blocks and tried to fire her up! After some initial panic when it didn't fire up right away(due to the fuel line being dry?) and a minor throttle cable adjustment, it seems to run smooth with the new clutches. Next up....remove the oiler so I can premix the gas, then on to the "road test"!
|