Quote:
Originally Posted by dundeebarnbuggy
I have done a search and came up inconclusive. Does anybody know the setting for a DPI charger with the jumper pins for Crown [CR-190] batts? Found a setting for everything but!
|
Dundee,
The recommended mode for Crown can be seen on Page 5 of the Gen 3 manual:
http://www.dpipower.com/store/MNUL/General_Chargers.pdf
I also have recent confirmation from DPI that Mode 4 is their recommendation and this applies to both CR-165 and CR-190 batteries. I have been using Mode 4 on my CR-165 batteries for 9 months now. I can can confirm no excessive gassing, my electrolyte levels remain at their factory fill levels ~ 3/4" above the plates, and I have experienced no significant temperature elevation using Mode 4.