[joehrs]

99 ezgo txt series 36v


*CONTROLLER OUTPUT Connect (-) probe to M- terminal.*
Connect (+) probe to B+ terminal.*
The reading should indicate approx. 0 volts.
Slowly depress accelerator pedal.*
The reading should show the voltage increasing to battery voltage when fully depressed. If the voltage is at or near battery voltage and the motor is not turning, then the problem lies in either the forward/reverse switch, the wiring, or the motor.
If the voltage increases by a few volts and then stops changing while the pedal is being depressed, remove the orange wire at the "Reverse Micro switch".*
If the voltage is not at or near battery voltage, replace the controller.*
If battery voltage is present, the problem lies in the reverse circuit.*
Re-connect the orange wire.


Cart is running
passed all tests.......but is only getting 35.1v fully depressed
is this considered at or near battery voltage of 38?
Any ideas
thanks