Re: Is oil injecting?
....you could drain gas, run pre-mix, simply disconnect oil line that runs to the intake manifold and abandon in-place. That way after you ride, you will see oil on and around your motor (not the cleanest thing to do, but mine was disconnected when I bought and just pumping oil/dripping... .) OR, you could buy clear tubing and simply replace the short line from the same manifold area down to the pump, run premix [again], then after your ride see if the tube fills with oil... .
In both scenarios you could jack the rear wheels, remove the seat, start, then a do a look-see (which might be easier for you).
...just some other thoughts.
|