Quote:
Originally Posted by cableguy_hd
ok guys, Thanks for the help but if all possible I'd like to start over on the trouble shooting. I went and reread this and did some tests. Here is what I found.
1. back nut on F/R is as tight as it will go
2. The wrench made no difference on the F/R
3. Have pack voltage at M- & B- and voltage does not go down when pedal is pushed
4. No green led on controller
5. Checked pin 1 on connector while on controller ( I have 1 pc connector not 4 pins )
I checked by putting dmv on pack neg and pos on the back of said connector and when pushing pedal it was 13.2v and stayed the same when pedal went to floor.
|
4. No Green LED means the controller is not powering up.
Is the solenoid clicking when pedal is pushed? (Solenoid is energized and controller is powered up by same voltage fro pedal switch)
Get that fixed and the cart will probably run.
5. If your controller has the single molex connector instead of four separate push-on connectors, Pin-1 is part of the ITS.
Pin-4 is the one that turn the controller on.