Quote:
Originally Posted by simple man
The dropping to 4Ω at full pedal is not correct, but the cart should run until the pedal is all the way down.
|
I think I pinned the push rod back into the wrong hole on the pot arm and so it is over traveling. As you say though, it should still run until it reaches that point I think.
Thanks again for that link to EZ-Go tech site. That is the first worthwhile printed material I've seen for this cart. There are some differences between what I found there and my Titan, but they are very similar.
I will try jumping the solenoid as you say, but it sure looks like I'm going to need a speed controller. I'll carefully mark all the wires and remove the box and see if I can find some identifying print on it. From what I've looked at online, it sure seems to be a Curtis control of some kind.