[cart de golf]

I took the picture you had posted of your governor I put arrows with numbers for dirrection

1 loosen out to original position

2 look behind there is a 10mm nut loosen it

3 pry up the asembly 1/4 inches of the shaft that comes out of the transmission

4 you will see from the top the bracket is D shaped , you take a 5/16" drill bit & round it out to get rid of the D shape so the bracket can spin freely on the shaft

3 push back at original spot

2 take lock tigh or paint nail polish put it on treads & just tighten by hand no pressure

if you ever sell the cart you can just spot weld it back in place if needed

I hope this clears it up