View Single Post
Old 04-04-2010, 12:15 PM   #20
gutterboy2ca
Not Yet Wild
 
gutterboy2ca's Avatar
Yamaha
 
Join Date: Aug 2009
Location: New Brunswick,Canada
Posts: 54
Default Re: Modifying Governor on G16 & G22

Heres a couple more pics to throw in thre thread,came out pretty clear with my Fuji,hope it helps, BTW its on a G14, should be same i assume.I also removed the Muffler,pretty much a must to get the arm off the shaft to Drill it out"all in all took about 15 mins, all stock, Garmin GPS's it at exactly 24.8mph on level ground.
Attached Images
File Type: jpg D-Head on stud.JPG (37.5 KB, 409 views)
File Type: jpg Loosen 10mm Bolt(mine was welded).JPG (43.2 KB, 395 views)
File Type: jpg Drill hole Round.JPG (40.2 KB, 398 views)
File Type: jpg Re-install arm(make sure its Loose).JPG (37.1 KB, 410 views)
gutterboy2ca is offline   Reply With Quote