View Single Post
Old 08-13-2010, 05:22 PM   #1
1idman
Not Yet Wild
E-Z-GO
 
Join Date: May 2009
Location: Pickering, Ontario. Canada
Posts: 4
Default 97 workhorse runs on one cylinder only

I just bought a workhorse, it had been sitting for about 4 months. I put in a new battery and it ran fine. I got it home drove it around for awhile, all seemed fine. as the days went on it became harder and harder to get it started. Today I could not start it at all. I found that it does start when I take the plug wire off the second cylinder I swapped the plugs and same thing . I do have spark from both ignition wires , but if I try to start with only the second cylinder or both wires on , it will not start. Any ideas what to do next?
1idman is offline   Reply With Quote