Thread: Does it work
View Single Post
Old 09-12-2012, 06:29 PM   #4
rvkersh
Gone Wild
 
rvkersh's Avatar
E-Z-GO
 
Join Date: Apr 2012
Location: Dansville, NY
Posts: 396
Default Re: Does it work

If it is an ezgo,split the driven clutch, remove the shim and mill it down to a 1/16 thick. This make the belt ride a 1/16 to an 1/8 above the outer edge. This gives good low end and doesn't affect the top end. I personally prefer this over the stresses of the shorter belt, and it's free. Your choice.
rvkersh is offline   Reply With Quote