[cgtech]

that sounds great, but, the problem with the TEAM input shaft governor collar will only be amplified by putting even more force on it. that is why i tell anyone who will listen not to flip the original spring. this goes against everything i have been trying to discuss/fix with TEAM. the dana axle had several revisions to fix the same problem in the dana axle. Dana finally fixed it by putting a torrington bearing (flat roller) on the governor collar. until a true fix is put in this axle, i will not recommend putting any more force on the collar than turning up the stock 10mm nut (zip tie is the same as this). if you have not seen the razor-sharp worn out collar problem yet, wait a couple of years, you will understand later.