View Single Post
Old 06-17-2007, 01:55 PM   #6
NO NO NO E-Z-GO!
Gone Wild
 
Join Date: Dec 2006
Location: ComplainAboutNoNo'sProfile-Ville
Posts: 4,995
Default Re: Question about Motor Terminals

It's a vent tube. All differentials generate pressure and release it all the time (thanks Roady ). It needs that for the vaccuum. Make sure there is nothing in it!

If you want to change the gear oil, there is a 17mm (if I remember correctly) drain plug on the bottom of the differential. Drain all the gear oil out, pull the vent tube (entire assembly) out and you'll have a nice, big hole to fill it back up. There is a 10mm bolt that is the full level. Remove it and fill thru the vent hole until oil runs out the 10mm bolt hole. Put the vent cap back in and you're good to go.

Last edited by NO NO NO E-Z-GO!; 06-17-2007 at 02:00 PM..
NO NO NO E-Z-GO! is offline   Reply With Quote