Re: Ausco cable disc brake install thread
Not quite sure if this has been covered, or not, but these pads are not "use 'till it gets down to the metal backing plate". They eventually wear thin enough that they can't be properly adjusted, and that point is before the "meat" of the brake lining is totally gone. Hope this will help someone, it has helped me with troublesome ones. And, yes, the washers sometimes have to be tried, and reconfigured at initial installation to get everything right. This was a fun one on a electric RXV axle. yes I welded brake mounting plates on a hotrod Rxv axle, getting the pedal group to play nice could be a project in itself (I'm sure glad the bellcrank mounting point is included on all frames!)
|