Quote:
Originally Posted by Night life
-snip-
The mcor test the numbers were all off a little. Higher or lower not by much. (How accurate does the range need to be?)
while testing the mcor limit switch. Negative to pack negative, + on the green wire on the 2 pin mcor connector. I don’t get any volts when pressing the pedal.
Can i assume the mcor is bad and that’s my issue?
Thanks
Barry
|
With the batteries connected, key switch Off, Tow/Run switch in Run; place the black (–) probe on packs main Negative post and the red (+) probe on the yellow wire at the 3-pin connector near the MCOR. (The reading should be approximately ~0.32vdc to ~0.5vdc with the pedal up). Slowly press the Go Pedal and the readings should increase until it reaches ~4.65vdc or more when the pedal is fully pressed. (Anything less than 4.60vdc and you are not reaching full throttle). If the reading is erratic or jumps all over the place it is a bad MCOR potentiometer..... Get one here
https://www.revolutiongolfcars.com/mcors