View Single Post
Old 10-07-2007, 12:21 PM   #11
Tuco
Not Yet Wild
 
Join Date: Oct 2007
Posts: 4
Default Re: Removing an EZGO clutch

New to the forum. I have posted this question on two others but they don't seem as detailed as this groups forum. I have a 1995 EZGO with a 295. I am in the middle of an engine replacement, bored 295 from Motors and More, and have the engine out. I am down to removing the clutch. The folks I bought the motor from loaned me a puller so I have the handled. The problem I am having is removing the center bolt to start with. I have sprayed some penetrating oil on it and in what appears to be whole to either vent moisture or use for lubricating. Hope I have not done damage with the oil. I can not seem to break the bolt loose. I don't have an impact wrench. Any suggestions?
Tuco is offline