Re: Ausco disc brake install Precedent Club Car
OK, almost finished. Here is a tip that is not in the directions. The parts all come as bare metal. This stuff would rust the first time it gets wet. I masked off the brake pads and the part of the rotors where the pads would make contact and painted everything with industrial spray cans. Turned out nice and will keep it somewhat sealed. So, the next step is to take the mounting bracket and bolt it to the axle tube (on the outside lip) with the four bolts you saved from the brake assembly. (all are 1/2" bolts) Directly afterwards carefully slide your axle back in and replace the snap ring. I like to push on the snap ring in a few spots with a flathead screwdriver to make sure it is seated properly.
|