Buggies Gone Wild Golf Cart Forum - View Single Post

sho305 · 12-06-2012, 10:09 PM

If I were going to paint it I would use the fine sand, it would make the paint stick better. It does not remove much material unless you hammer it over and over while blasting.

Yeah, only do the outside!

Even that cheap spray can engine degreaser will take dirt and oil off, especially if you rinse it with a pressure washer closely.

Can you buy the button holes anywhere? I was at a place that used those. They can take the paint off coat by coat if they want. Did a lot of vettes and boats there.

12-06-2012, 10:09 PM	#6
sho305 Vegas modded 420 Join Date: Jun 2009 Location: West MI Posts: 15,445	Re: sand blasting block If I were going to paint it I would use the fine sand, it would make the paint stick better. It does not remove much material unless you hammer it over and over while blasting. Yeah, only do the outside! Even that cheap spray can engine degreaser will take dirt and oil off, especially if you rinse it with a pressure washer closely. Can you buy the button holes anywhere? I was at a place that used those. They can take the paint off coat by coat if they want. Did a lot of vettes and boats there.