Buggies Gone Wild Golf Cart Forum - View Single Post

pjpolk · 07-26-2014, 03:28 PM

Thanks that’s good news,

I will check the batteries for the voltage, and also look into the 42v set up as well; have room on the driver’s side for another battery.
As for the run/tow switch, Scotty’s instructions were after cutting the cover, to mount it back on the plate but it will not fit with the new controller in place, so the bottom of the seat will be a good fit.
The new motor is almost a must, the previous owner stated he had replaced the motor recently in turn when the new controller was changed I did find #4 cable already installed. I renewed all the cables just for self-satisfaction, and confidence.

I will more than likely do the same with the motor.

07-26-2014, 03:28 PM	#7
pjpolk Not Yet Wild Join Date: Jul 2014 Location: Denham Springs, Louisiana Posts: 7	Re: Motor & Solenoid to hot to touch Thanks that’s good news, I will check the batteries for the voltage, and also look into the 42v set up as well; have room on the driver’s side for another battery. As for the run/tow switch, Scotty’s instructions were after cutting the cover, to mount it back on the plate but it will not fit with the new controller in place, so the bottom of the seat will be a good fit. The new motor is almost a must, the previous owner stated he had replaced the motor recently in turn when the new controller was changed I did find #4 cable already installed. I renewed all the cables just for self-satisfaction, and confidence. I will more than likely do the same with the motor.