[Jhammer]

So update I have lights horn turn signals and everything however still no movement. I have checked the signal from the 7 pin harness to the throttle and everything is checking out. I have proper voltage to the key and everything. The motor I was told is new the controller is my big concern now. I have checked the the 23 pin connector on the controller by back probing it and have only seen 2 issues. One is that pin 11 should have 48 volts till the accelerator is pressed and then it should go to 0 however my volt meter shows no difference in voltage when pressing the pedal. I have another issue I have not only a tow/run switch but another switch which does not look factory near that switch it says controller switch on for use by qualified technicians only. That yellow wire from pin 11 goes to that switch, does this seem right and does anyone have one of these switches including their Tow/Run switch why and what does it do??