Buggies Gone Wild Golf Cart Forum - View Single Post - 2008 Tomberlin Emerge hall effect senor issue

ojo · 04-13-2022, 04:55 PM

Ok, motor tested and running... that's good to know!
But i'm not sure, you're expecting the correct values when measuring?
The red wire on the sensor should show 48v. When pedal is pressed, the microswitch should click and there should be 48v on the green wire of the switch. While pressing the pedal slowly, the voltage on the blue wire of the sensor should increase from .5 to 5v!

When measuring on the controller side:
Pin 3 (from footswitch) with pedal up > 0v, pedal pressed > 48v
Pin 7 ( sensor signal ) with pedal up > .5v, pedal pressed > up to 5v

04-13-2022, 04:55 PM	#29
ojo Gone Wild Join Date: Sep 2020 Location: Germany Posts: 1,996	Re: 2008 Tomberlin Emerge hall effect senor issue Ok, motor tested and running... that's good to know! But i'm not sure, you're expecting the correct values when measuring? The red wire on the sensor should show 48v. When pedal is pressed, the microswitch should click and there should be 48v on the green wire of the switch. While pressing the pedal slowly, the voltage on the blue wire of the sensor should increase from .5 to 5v! When measuring on the controller side: Pin 3 (from footswitch) with pedal up > 0v, pedal pressed > 48v Pin 7 ( sensor signal ) with pedal up > .5v, pedal pressed > up to 5v