[scottyb]

I used to adjust every 0-5k pot we sold with the old version 1 conversion kits. This kit required the pot to reach max throttle at certain travel point which was sooner than it's design.
Not too hard to change. Simply loosen the center shaft retainer nut and rotate the shaft a bit then snug it down and recheck the out put to see if you went far enough or the right way.... repeat until you get the desired result and then lock it down.
We learned that 0-4600 produced the same 100% signal as a true 5000Ω signal for our controllers, so we typically shot for 4800. Hope this helps